6.1 Hemi into 72 Demon March 2018

Sublime one said
View attachment 1715164925 View attachment 1715164926 View attachment 1715164927 View attachment 1715164928 View attachment 1715164929 View attachment 1715164925 View attachment 1715164926 View attachment 1715164927 View attachment 1715164928 View attachment 1715164929 full]1715164926[/ATTACH] View attachment 1715164928 View attachment 1715164928 View attachment 1715164929 So I am a bit behind as I went to seasons first car show here in Fargo last weekend and over walked my knee so ended up in chair with ice pack. Not really doing anything on the Demon.
This weekend however I am back in full stride. As you can see from the pictures I have been focusing on releasing the Hemi from the spaghetti wire harness. I have basically got all the connections bagged and tagged. I had to buy a fuel rail connector tool to unconnect the fuel line stuff. Amazon says it will deliver on Monday. All these new fangled connectors are a pain in the butt. And yes before I get flamed into oblivion I fully realize they are faster cheaper and more effective. In like manner so is a B1 bomber but i still think a B29 Is way cooler! Enjoy the pictures and I will see what tomorrow brings.

So finally got the gen 3 up in the air, now I will build a carriage for it so I can roll it around safely, then drop Demon down over it. If you look close I fabricated a spreader bar to pick up the motor with. It is constructed of 2 by 2 by 1/4 wall sq tubing. I put a couple slide stops in the center just in case it slid on the tubing, I spaced them out just past the oil pan. The pickup points are just outside the headers so I can swap headers while it is in the air. I ordered a set of TTIs (ouch). Hav a great week to all