So finally got the gen 3 up in the air, now I will build a carriage for it so I can roll it around safely, then drop Demon down over it. If you look close I fabricated a spreader bar to pick up the motor with. It is constructed of 2 by 2 by 1/4 wall sq tubing. I put a couple slide stops in the center just in case it slid on the tubing, I spaced them out just past the oil pan. The pickup points are just outside the headers so I can swap headers while it is in the air. I ordered a set of TTIs (ouch). Hav a great week to all
View attachment 1715165427
View attachment 1715165428
View attachment 1715165429
View attachment 1715165430
View attachment 1715165431
View attachment 1715165432