1965 MMP's Barracuda Hemi swap! The Ever Changing Build
Been slow going lately. Went through 3 different caliper rebuild kits till I got the right ones, two different sets of pistons. ugh
But finally got what I needed to finish the calipers. I sand blasted the lower arms and bought the material needed to cut them down to size.
I was hoping to get to this but it's going to have to wait a few weeks. Other than that I haven't been able to get much finished. I was able to reassemble the Whipple supercharger yesterday. All cleaned and rebuilt, didn't take any pictures but will post some finished ones later. Still need to build a rear throttle plate manifold to accommodate the corvette throttle body. I also want to pull the motor and finish up the build, pulleys and water neck but with out a rear-end in the car moving it around is a bit tough. So I'm thinking about building bolt on frame dolly wheels so I can at least get it off the jacks and move it around.
Been slow going lately. Went through 3 different caliper rebuild kits till I got the right ones, two different sets of pistons. ugh
But finally got what I needed to finish the calipers. I sand blasted the lower arms and bought the material needed to cut them down to size.
I was hoping to get to this but it's going to have to wait a few weeks. Other than that I haven't been able to get much finished. I was able to reassemble the Whipple supercharger yesterday. All cleaned and rebuilt, didn't take any pictures but will post some finished ones later. Still need to build a rear throttle plate manifold to accommodate the corvette throttle body. I also want to pull the motor and finish up the build, pulleys and water neck but with out a rear-end in the car moving it around is a bit tough. So I'm thinking about building bolt on frame dolly wheels so I can at least get it off the jacks and move it around.