1972 Canadian H-Code 340 Dart Swinger Special Resto - Finally started!
Did a bit of work, started by spraying some wax oil rustproofing in my doors and quarters so I can seal them up with the vapour barrier my pal Joel got me from Performance graphics,
Vapour barrier went on with the cay cord and a pretty a wide tape that matches what the factory used, I used the cord on the top and sides the tucked the barrier in the slot and taped it in place at the bottom,
Made sure my seat belt harness was in place then wrapped the floor in a heavy jute I got from a fellow Special owner and buddy Richard, the new carpet had hardly any jute on it so this was a nice solution,
Well I think the carpet was in the box a bit too long, sat out in the sun to heat it up so it would form up but no such luck so looks like I'll need to steam it in order to get it to fit.
Did a bit of work, started by spraying some wax oil rustproofing in my doors and quarters so I can seal them up with the vapour barrier my pal Joel got me from Performance graphics,
Vapour barrier went on with the cay cord and a pretty a wide tape that matches what the factory used, I used the cord on the top and sides the tucked the barrier in the slot and taped it in place at the bottom,
Made sure my seat belt harness was in place then wrapped the floor in a heavy jute I got from a fellow Special owner and buddy Richard, the new carpet had hardly any jute on it so this was a nice solution,
Well I think the carpet was in the box a bit too long, sat out in the sun to heat it up so it would form up but no such luck so looks like I'll need to steam it in order to get it to fit.