6.1 Hemi into 72 Demon March 2018
Sorting out more wiring tonight. Yes it is a total pain in the butt for someone of my limited electrical knowledge. There is likely a smooth professional way to do it but all I know to do is make a hanger board, seperate them out label then find corresponding plug on engine. I will preconnect all of them prior to putting engine in place for final time then create a bulkhead penetration. I also included a simple snap type ring pictures that goes on the hyd hose from slave to throw out bearing. Went to Dodge dealer and they simply will not sell clip only, frankly I don't think they can figure out how as it does not have a individual part number. They are however more than willing to sell entire assembly for a mere 300 some odd bucks. I will figure out a way to not use the honking OEM clip! Jerkoffs.
Sorting out more wiring tonight. Yes it is a total pain in the butt for someone of my limited electrical knowledge. There is likely a smooth professional way to do it but all I know to do is make a hanger board, seperate them out label then find corresponding plug on engine. I will preconnect all of them prior to putting engine in place for final time then create a bulkhead penetration. I also included a simple snap type ring pictures that goes on the hyd hose from slave to throw out bearing. Went to Dodge dealer and they simply will not sell clip only, frankly I don't think they can figure out how as it does not have a individual part number. They are however more than willing to sell entire assembly for a mere 300 some odd bucks. I will figure out a way to not use the honking OEM clip! Jerkoffs.