Tunnel Ram Throttle Cable/Linkage

matthon said
Not stuck on stock throttle cable at all, it just didn't look like there was enough room to bring the cable up, and have a bracket there too, without cutting the hoid back to the firewall.

Looks like you got it done w/o issues. I like the diy inline linkage, I'll have to fab one up.

Did the lokar cable replace the stock one without modifying anything?

If you know the part #s that would help.

Yes the lokar one just bolts right in wear the stock one goes. The lokar has a nut that you unscrew off the cable. Push the cable through the factory hole in the fire wall and then just install the nut and tighten it up. I might not if explained it very good but once you have the cable in your hands you will see what I am talking about. Here is the two parts you will need. These are in stainless but they make the cable in Black that is a little cheaper I think.