Ball joint replacement

Ok thanks I'm gonna try and save them at all cost they are not cheap to replace and they are not in the budget lol what's the best way to get the pivot pin out with the torsion bar still in? On the other side I had to press the pin out of the lca with a bolt from the inside of the lca. Could I heat the rubber on that side without heating the bar maybe?

If the bar will slide out the back of the anchor, just take the nut off the pivot pin and slide the whole thing back until you can get at the LCA to knock it off the end. The pivot pin can stay in the LCA until you've knocked it off the torsion bar, then you can press it out.

And, I don't think there's anything to save with those torsion bars. As crusty, rusty, and frozen as those suspension parts have been for you, I wouldn't reuse those torsion bars, period.