What guide plates are you guys using on magnums?

I used the comp cams 4825-8 on my 5.9 magnum with EQ heads. They worked ok and I could adjust them to get the alignment correct. the problem I had was the QC wasn't the greatest and a few of them were tight on push rods after tightening down the rocker studs (the plate would distort and cause the pushrods to hang up slightly). I guess what can you expect for $20... it sure aint CNCed lol

I actually went through and ordered like 4 sets from summit to see if they were all like that or if I had a bad set. Every set I looked at did the same thing. So I ended up just clearancing them slightly for a few minutes with some really high grit sand paper and it worked out fine.

COMP Cams Pushrod Guideplates 4825-8