Magnum swap 65 Dart, pass. side manifold issues

mycuda said

Between oil filter and torsion bar, steering link, and 4spd bell cast.
No where for exhaust???????

Have temp 2 1/8" flex pipe tack welded to manifold.
All I can figure is use a 90* pipe fitting off manifold but still will interefer with oil filter, with or without adapter? need remote filter set up???:mad:

Thanks.Dave

Click to expand...

Dave, I had to run the filter adapter and use the 273 manifolds on my Magnum. I also used the stock cross over pipe off the pass side manifold. Both pipes run back on the drivers side until they get past the transmission cross member then it crosses over and comes down the pass side. Not much room to run a pipe on the pass side past the trans even if you mod the cross member.