69 Notch Barracuda - Rebirth
Dialed in the Bellhousing. This went very well. The most difficult part was setting up the damn dial indicator :realcrazy:. I tried a couple of different methods but liked the Hurst method best. In the end my runout was .013” from farthest to closest of centerline. Divide that by 2 to get .007” from center... so that’s the size offset dowel pins I’ll buy from Robbmc Performance. Pins will be clocked to shift Bellhousing in the direction of the silver mark (0), the side closest to the centerline. At least... I think I’ve got it all figured out ;)
Dialed in the Bellhousing. This went very well. The most difficult part was setting up the damn dial indicator :realcrazy:. I tried a couple of different methods but liked the Hurst method best. In the end my runout was .013” from farthest to closest of centerline. Divide that by 2 to get .007” from center... so that’s the size offset dowel pins I’ll buy from Robbmc Performance. Pins will be clocked to shift Bellhousing in the direction of the silver mark (0), the side closest to the centerline. At least... I think I’ve got it all figured out ;)