Rapom's Rocket - just another Duster build thread
So I had to cut the hump in half right in front of the shifter hole, drill out all the spot welds on the rear half, cut the floor pan back, reshape the whole back edge of the hump to go over the ridge for the seat mounts, weld in a 1" strip of trunk skin (man that trunk lid has come in handy), re-weld all the spot welds and grind, seal and paint everything again. Still can't figure out why it was off in the first place. Friggin headache.
So I had to cut the hump in half right in front of the shifter hole, drill out all the spot welds on the rear half, cut the floor pan back, reshape the whole back edge of the hump to go over the ridge for the seat mounts, weld in a 1" strip of trunk skin (man that trunk lid has come in handy), re-weld all the spot welds and grind, seal and paint everything again. Still can't figure out why it was off in the first place. Friggin headache.