8.8 swap
Only one RH perch remaining to cut off, but the left sides finally ready for the big cut down. Used an air angle grinder with cutoff discs and some grinding pads. Worked this ***** over in 100° heat today from about 11am to 4pm. Then hit it with a light coat of rattle can primer so i can mark it for where it needs to be cut, and keep flash rust off of it. I am betting that cutting these damn brackets off and grinding all that **** flat is the worst of it all.
Only one RH perch remaining to cut off, but the left sides finally ready for the big cut down. Used an air angle grinder with cutoff discs and some grinding pads. Worked this ***** over in 100° heat today from about 11am to 4pm. Then hit it with a light coat of rattle can primer so i can mark it for where it needs to be cut, and keep flash rust off of it. I am betting that cutting these damn brackets off and grinding all that **** flat is the worst of it all.