408 Stroker Build Suggestions

Here is what I have:
1992 magnum block
Scat 4" stroke crank
Scat forged i-beam rods
Diamond flat top pistons (11.8:1 compression)
Total seal rings
Engine Pro main, rod, Cam bearings
Fluid damper
Cloyes double roller timing set
Cometic head gaskets
Edelbrock performer rpm heads (gasket matched w/ light porting)
Smith bros pushrods
Comp 1.5 ratio shaft mount billet roller rockers
Comp hydraulic roller lifters
Comp Cam
242/248 Dur@ .050, .3660/.3630 lift @ .050, 112° lobe sep. 549/544 gross valve lift
Comp valve springs, retainers, keepers, locators
ARP head studs
ARP bolts used throughout
Melling high volume oil pump
Edelbrock RPM Air Gap intake
MSD Pro Billet distributor
bronze dist gear
Taylor wires and looms
NGK plugs
Holley 750dp mech secondary manual choke
MSD 6AL-2 Programmable ignition box
Blaster2 Coil

It sits right at 500 hp and I run 93 octane pump gas. It is such a torque monster! I love this engine. It's not a great racer on the highway because at 80 mph the torque is not all there at that speed, but I never lose off the line. I've had it to 145 mph and had a lot to go. It's a great motor and you will never regret building it.