67/68/69 cuda dilemma
Cut off the stupid looking "ears" on either side of the sensor location on the rear axle housing, and reshaped the metal. They were probably fine when it was under an xploder. Probably there to protect the sensor if the truck was taken offroad. No longer needed. I wire wheeled the general area around where i cut with an aggressive wire wheel on my angle grinder, and shot it with a little rustoleum primer. I will likely leave the strengthening rib on the left side, but file it down a bit more to where it tapers in better. I will probably will remove the nub thats remaining on the lower left side. Looks much better so far IMHO
Cut off the stupid looking "ears" on either side of the sensor location on the rear axle housing, and reshaped the metal. They were probably fine when it was under an xploder. Probably there to protect the sensor if the truck was taken offroad. No longer needed. I wire wheeled the general area around where i cut with an aggressive wire wheel on my angle grinder, and shot it with a little rustoleum primer. I will likely leave the strengthening rib on the left side, but file it down a bit more to where it tapers in better. I will probably will remove the nub thats remaining on the lower left side. Looks much better so far IMHO