904 Transmission Stopped Going Into Gear
This is what the guts look like with the following conditions:
-no frictions or steels in either drum
-no band on direct drum
-no oring on pump
-pump bolted in to torque spec (175in-lbs)
-thrust washer greased in place between input and output shafts
-fiber thrust washer greased in place on front of forward drum
In this state there is a gap as shown in the tabs on the sun gear shell and the input shaft is too tight to turn by hand and has no measurable end play.
When I loosen the the pump bolts just a little bit, the input shaft spins nice and easy and I start to get some endplay.
What am I doing wrong?
This is what the guts look like with the following conditions:
-no frictions or steels in either drum
-no band on direct drum
-no oring on pump
-pump bolted in to torque spec (175in-lbs)
-thrust washer greased in place between input and output shafts
-fiber thrust washer greased in place on front of forward drum
In this state there is a gap as shown in the tabs on the sun gear shell and the input shaft is too tight to turn by hand and has no measurable end play.
When I loosen the the pump bolts just a little bit, the input shaft spins nice and easy and I start to get some endplay.
What am I doing wrong?