904 Transmission Stopped Going Into Gear
I took everything apart and took a picture at every step, let me know if anything looks wrong.
Both rings and one thrust washer on back of pump. Rings are both locked and everything looks fine. Pump slides into direct drum smoothly.
Thrust washer in forward drum.
View once forward drums are removed. Original shaft thrust washer is held in place with grease.
Removing front planet assembly. Thrust washer greased in place.
Removing shell. There is a steel ring on back of shell. The rear planet thrust washer is held in place with grease.
Looking into rear ring/reverse drum.
Rear ring removed.
Extension housing is attached to case, this is a pic of the output shaft bearing retaining ring. It looks fully seated in the groove which is biased towards the front of the transmission.
When I install everything (with no frictions, forward band, or pump o-ring), the input shaft spins freely and has some endplay until I start to snug the pump bolts . If I get the pump bolts snug or tight, the input shaft is not free to turn by hand and there is no endplay....
Does anyone see anything missing/wrong so far?
I took everything apart and took a picture at every step, let me know if anything looks wrong.
Both rings and one thrust washer on back of pump. Rings are both locked and everything looks fine. Pump slides into direct drum smoothly.
Thrust washer in forward drum.
View once forward drums are removed. Original shaft thrust washer is held in place with grease.
Removing front planet assembly. Thrust washer greased in place.
Removing shell. There is a steel ring on back of shell. The rear planet thrust washer is held in place with grease.
Looking into rear ring/reverse drum.
Rear ring removed.
Extension housing is attached to case, this is a pic of the output shaft bearing retaining ring. It looks fully seated in the groove which is biased towards the front of the transmission.
When I install everything (with no frictions, forward band, or pump o-ring), the input shaft spins freely and has some endplay until I start to snug the pump bolts . If I get the pump bolts snug or tight, the input shaft is not free to turn by hand and there is no endplay....
Does anyone see anything missing/wrong so far?