Cylinder head valve job
I do have a drawn-out listed things that I would like to do as I checked through this stuff but I thought it easier to fall out YouTube it in my voice command LOL. My question is how did you attach that picture or pictures to this post? For some reason your picture didn't pop up in my phone maybe I'll turn it off and try going this up again? But if I could pinpoint it.you can pull the shafts and eyeball what valves are sunk, but that assumes the seats are not sunk either. Good find on the valve. Sometimes intakes get coked and they dont close properly. Seafoam would have probably cleaned that. Exhaust valves get burned and sometimes gouge at the rim in extreme cases. With the heads off, start pulling valves and checking. Not difficult with some direction or at least some advice. I made a seat "scraper" with an old valve and a carbide cutting tool tip, I tack welded it in a cut slot at 45 degrees and could use it to cut or at least scratch the valve seat clean using a drill. very slight chatter View attachment 1715234406 View attachment 1715234407 View attachment 1715234408 View attachment 1715234409 View attachment 1715234410
