383/438 Build
Setup the Apex hydraulic throw out bearing tonight. Surprisingly easy. I ended up not needing any shims. The clearance range is .150"-.200". I had .150". I went ahead and drilled a dimple into the input bearing retainer to give the set screw a place to seat. Some red locktite for good measure. Gonna stab it in tomorrow and measure for driveshaft length.
Setup the Apex hydraulic throw out bearing tonight. Surprisingly easy. I ended up not needing any shims. The clearance range is .150"-.200". I had .150". I went ahead and drilled a dimple into the input bearing retainer to give the set screw a place to seat. Some red locktite for good measure. Gonna stab it in tomorrow and measure for driveshaft length.