68 Dart Project.
Made the rear bars today. 36 degree bend put them through the speaker holes nicely, no problem fitting the rear seat.
A couple of 6" flat plates and things can start getting welded up.
A picture off of the net, liking the door bar location. Very manageable, simple, no swingout needed, will likely go with this.
Did a little wheel opening planning at the end of the day. Threw a wheel into place and blacked out the area that will be removed. A long ways to go, getting this right and templates made before cutting the old quarter off.
Made the rear bars today. 36 degree bend put them through the speaker holes nicely, no problem fitting the rear seat.
A couple of 6" flat plates and things can start getting welded up.
A picture off of the net, liking the door bar location. Very manageable, simple, no swingout needed, will likely go with this.
Did a little wheel opening planning at the end of the day. Threw a wheel into place and blacked out the area that will be removed. A long ways to go, getting this right and templates made before cutting the old quarter off.