1972 Duster Build with my Daughter
Now insert the grease pad into the rear cap and pack grease in this area for the bushing..
The kit comes with different fiber washer so I started with them all.
When I put the cap on I could not get it to seat completely so I was sure there were too many washers so I removed the thick one.
That was much better. Don't want the starter spending energy just trying to get itself to spin from being to tight.
Put the cap on then install the long bolts. When you put them in **** them so they slide down the side of the magnet housing to insure the one slips behind the cardboard insulator. Before you put the cover on a good flashlight will let you see down in that area to ensure that the cardboard is in the correct position so the bolt will go behind it.
Here is what we accomplished today. Need to put the AC compressor clutch back together and get the pulley pressed on and all the major accessories under the hood are ready for the homecoming of the 318!
Now insert the grease pad into the rear cap and pack grease in this area for the bushing..
The kit comes with different fiber washer so I started with them all.
When I put the cap on I could not get it to seat completely so I was sure there were too many washers so I removed the thick one.
That was much better. Don't want the starter spending energy just trying to get itself to spin from being to tight.
Put the cap on then install the long bolts. When you put them in **** them so they slide down the side of the magnet housing to insure the one slips behind the cardboard insulator. Before you put the cover on a good flashlight will let you see down in that area to ensure that the cardboard is in the correct position so the bolt will go behind it.
Here is what we accomplished today. Need to put the AC compressor clutch back together and get the pulley pressed on and all the major accessories under the hood are ready for the homecoming of the 318!