Bellhousing alignment...
What about being parallel with the block, are going to take that measurement. The reason I am asking , is because I am take these same measurement. My bellhousing bore to Center of crank was off 7000, divided by 2, should be within spec. When measured face of block to face of bellhousing I am out by also 10000. Not sure if I just shim low side, or is there other solutions. This is with scatter shield attached. With shield it was 7000 out. Think the maximum allowance is 2000.
What about being parallel with the block, are going to take that measurement. The reason I am asking , is because I am take these same measurement. My bellhousing bore to Center of crank was off 7000, divided by 2, should be within spec. When measured face of block to face of bellhousing I am out by also 10000. Not sure if I just shim low side, or is there other solutions. This is with scatter shield attached. With shield it was 7000 out. Think the maximum allowance is 2000.