65 Barracuda daily driver
I had already read that the wheel cylinders in the rear were most likely going to lock up the brakes in combination with the discs up front, but when I swapped out the rear end I couldn't get the right cylinders with the smaller bore in time. So I've been driving like this and it is actually quite dangerous, because the brakes lock up quite easily. Luckily I was able to swap them out without taking all of the brakes apart. I also took the dash cluster, because the fuel and temp gauge and some of the dash lights had a short. And I lubricated the speedo, because the needles is a bit bouncy sometimes. I just remembered this moment that I haven't reconnected the speedo cable. I should write a note to not forget... I wanted to get it done quickly, so I forgot to take more photos.
I also finally put the front bumper back on. It's not very straight and the chrome is bad, but I'm not willing to shell out 600 bucks for a new one. After this photo was taken I realized that the side of the bumper was pointing down somehow, but I was able to bend it up a bit. Still need to take another photo.
I had already read that the wheel cylinders in the rear were most likely going to lock up the brakes in combination with the discs up front, but when I swapped out the rear end I couldn't get the right cylinders with the smaller bore in time. So I've been driving like this and it is actually quite dangerous, because the brakes lock up quite easily. Luckily I was able to swap them out without taking all of the brakes apart. I also took the dash cluster, because the fuel and temp gauge and some of the dash lights had a short. And I lubricated the speedo, because the needles is a bit bouncy sometimes. I just remembered this moment that I haven't reconnected the speedo cable. I should write a note to not forget... I wanted to get it done quickly, so I forgot to take more photos.
I also finally put the front bumper back on. It's not very straight and the chrome is bad, but I'm not willing to shell out 600 bucks for a new one. After this photo was taken I realized that the side of the bumper was pointing down somehow, but I was able to bend it up a bit. Still need to take another photo.