1972 Duster Build with my Daughter
Install the plate and screws.
Buffed out the turn signal arm and lined it up with my o-ring pick... Use lock tight on this screw or you will be sorry..
Wheel goes on next. Thought I was cool marking it but this wheel and shaft are indexed with a flat spot so it only goes on one way...
Horn mechanism bead blasted and cleaned.
Horn pad blasted and clear coated.
Like new'ish...
Horn wire connected.
Horn pad snapped on.
Someone at a desk thought a big heat shrink tube around the ignition switch wires was a good idea. Not in practice. Cut it back so it would fit in the harness cover.
Switches are universal so for a '72 the main power feeds just go to the main connector. Snapped them in.
Install the plate and screws.
Buffed out the turn signal arm and lined it up with my o-ring pick... Use lock tight on this screw or you will be sorry..
Wheel goes on next. Thought I was cool marking it but this wheel and shaft are indexed with a flat spot so it only goes on one way...
Horn mechanism bead blasted and cleaned.
Horn pad blasted and clear coated.
Like new'ish...
Horn wire connected.
Horn pad snapped on.
Someone at a desk thought a big heat shrink tube around the ignition switch wires was a good idea. Not in practice. Cut it back so it would fit in the harness cover.
Switches are universal so for a '72 the main power feeds just go to the main connector. Snapped them in.