Stop in for a cup of coffee
Swapped the drivers side disk on the G?Waggoneer. What a PIA. Would have been easier if I didn't have to go up a ladder to get to the hydraulic press. Had to install two at a time and then go back and check each one was fully sunk.
I didn't bother remove the old grease from the hub and doing thorough cleaning and repacking. No parts washer anymore across the way from my garage. :( The old grease seemed pretty good.
The Centric high carbon rotors are nicely machined and all that. Guess that's as good as one can ask for these days - especially when they're made in Ch**a.
Swapped the drivers side disk on the G?Waggoneer. What a PIA. Would have been easier if I didn't have to go up a ladder to get to the hydraulic press. Had to install two at a time and then go back and check each one was fully sunk.
I didn't bother remove the old grease from the hub and doing thorough cleaning and repacking. No parts washer anymore across the way from my garage. :( The old grease seemed pretty good.
The Centric high carbon rotors are nicely machined and all that. Guess that's as good as one can ask for these days - especially when they're made in Ch**a.