Last one to post in this thread wins!

Biff said
In all seriousness I need some advice, these mini tubs are kicking my butt after spotting them in I’ve been using a flap wheel on the welds , some like bubble gum (the up side down ones) so grinding them off then of course it gets thin again so I spit a little more weld ,grind some more , is there an easier way or just more patience?
Click to expand...
MIG? PICS?. Should not need grinding at all. Practice is what you need. If everything is set up correctly when moving to an overhead weld you might need just a tad more wire speed but welds should be flat when done . Sound like you need better penetration. ( no not the glove). Clean and tight and more heat.