Poorman’s alignment. First timer but everything passes the eyeball test. I’m sure it’s not perfect but it’ll get me down the road until I get it onto a proper alignment rack. Have researched some DIY tools but haven’t pulled the trigger.
Set my ride height. Did the string line around all fours. Then devised a straight edge on the rim with magnets. Used an manual angle finder but forgot I had my digital angle finder that I use for my table saw. From the looks of it I have the camber at -2* on the drivers side. Got -1.4* on the passenger side. These setting are with the cam bolts maxed just to see how much negative camber I could get. I have not figured out the Caster but will get the camber set to -.5 to .75 when I get a chance. I eyeballed the toe in at 1/8”. I’m looking forward the seeing how close or how far the actual numbers are on the rack.
View attachment 1715328831 View attachment 1715328832
View attachment 1715328838
View attachment 1715328833 View attachment 1715328835
On the sway bar the QA1 strut rods are a little thick. I believe I need to extend the end-link sleeves by 1/2-1” to clear the sway bar end. Opinions on this please. Sleeves aren’t straight up and down either and I’m not sure if I can do much about it either because of the L- brackets supplied by Hellwig.
View attachment 1715328836 View attachment 1715328837
View attachment 1715328834