Inspection of a 904 torqueflite

I see what you mean by calling the parts the wrong names.

What about all the other parts?

How do the other bushings look?

So far I’m going to replace
Gaskets
Seals
Sprag bearings and springs since they don’t cost much
Friction plates
Steels
The front pump bushing.



As far as the other bushings go....I don’t know. Depends on what it takes to get them out and back in. I’ve seen where they use special presses that I don’t have. I’m wondering if there is something else that would do it.....like a cam bearing installer. I do have a good one of those laying around.

I don’t know about the output shaft holder.....it looks like the output shaft rides on it.

And I’m looking into replacing the planets if they are bad.
The sun gear looks ok. I’ll post a picture of it

Should I put any sand paper to the the surfaces that the bands ride on? Like some 400 emry cloth