Keep in mind I will not be using a center console and I don't care if my interior looks original or not. I made the crossmember out of 1.5x3 square tubing - not the prettiest, but it's stronger than the old one. I held the crossmember in place using the original bolt holes, and then welded it in. The lower crossmember (made of 1/4" plate) is dropped maybe 1" in the center. Overall my upper crossmember is probably 2-3" higher than the original.
The TKO is bulky in the crossmember area. The speedo cable comes out directly in line with the crossmember which could be a problem for you (I will be using the electric speedo signal and plugging the speedo cable hole).
The engine isn't in the car, so I built a jig from the K-member to hold the TKO in the right place. It made things a lot easier when dropping the trans multiple times during test fitting. If anyone is interested I'll sell the jig cheap.
If you need more pics just ask...
Scott
View attachment 123240
View attachment 123241
View attachment 123242
View attachment 123243
View attachment 123244
View attachment 123245
View attachment 123246
View attachment 123247