Inspection of a 904 torqueflite

Ok.....never mind.
Those 4 thrust washers for the planets are .048-.050

It’s the Teflon’s that are .061-.063

This transmission isn’t even really worn out at all. It’s right on the edge of out of out of spec In some areas.

But it took 126k to lose .002 clearance on most of the parts.

In my opinion. I could run it for a long time and be fine. I would say so. The endplay is in spec no matter what.

The question is.....should I replace the planet thrust washers and the Teflon’s.

The other washer looks like it’s carved out. The outside is in spec but I doubt that inside piece is and it looks like it wears there....

I don’t know.....maybe you do. The picture of the new one doesn’t look like that.

The specs are right on the edge and some are right in the middle.
What do you guys think?

What do you do when your right on the line