Mr Gasket Verti Gate A-body shift rods and Mount.
I took those stock pieces that go through the shifter ear and found at the hardware store a piece threaded Rod something like carburetor studs. Where one end is fine thread and the other end is coarse thread. I was able to twist the fine thread into the stock end peace and then the coarse thread I was able to use a coupler to get it onto some allthread. Like I was saying I welded tabs on to the other end of the all thread, but I could have easily coupled some hem joints on... If that makes sense?
The first second shifter measured right at about 7 and 3/4 in and the third fourth shifter was right at 12 and 1/2 in from Center to center of eye.
I took those stock pieces that go through the shifter ear and found at the hardware store a piece threaded Rod something like carburetor studs. Where one end is fine thread and the other end is coarse thread. I was able to twist the fine thread into the stock end peace and then the coarse thread I was able to use a coupler to get it onto some allthread. Like I was saying I welded tabs on to the other end of the all thread, but I could have easily coupled some hem joints on... If that makes sense?
The first second shifter measured right at about 7 and 3/4 in and the third fourth shifter was right at 12 and 1/2 in from Center to center of eye.