View attachment 1715357539
His is the front planet set. Both of these thrust washers run .048
Are these not supposed to be .061 as said above?-
View attachment 1715357540
These are the rear planet set thrust washers. They run similar to the front......
.048 and .049 front and back-
View attachment 1715357541 -
This is the thickest washer. The one with the tab on it. It measures .124 .........The replacement shows .121 online.
I’m guessing*this one is fine.
However....look at the inside of it. Is that supposed to be that way or is that wear. I can’t get the caliper in there to measure it. This still has most of its copper color intact on the other side.
EDIT: (this washer controls the planetary gear train end play. The cut out in the middle that is mentioned above....that’s cause by the snap ring wearing into the thick washer. I think the spec for planetary gear-train endplay is .005-.045. If it shows out of spec. You can replace this washer AND THE SNAP RING)
The planets thrust washers should also be considered here. Mine is not out of spec. If I had to try to get it back into spec. I would measure the outside surface of this thick washer. Then replace it. And then check the spec again....then replace the planets thrust washers.....