Inspection of a 904 torqueflite
A999 worn down....output shaft support -
I think the output shaft support is worn down due to the .023 play in the governor area......a new and thicker snap ring should fix this.
Here is the 904.....the okay here is .016.......much smaller than the one above. I forget the spec. Will post it tomorrow
The thrust washers were .049
The thick one was .125 on part of it and .122 on part of it. It has the snap ring groove run down int it
A999 worn down....output shaft support -
I think the output shaft support is worn down due to the .023 play in the governor area......a new and thicker snap ring should fix this.
Here is the 904.....the okay here is .016.......much smaller than the one above. I forget the spec. Will post it tomorrow
The thrust washers were .049
The thick one was .125 on part of it and .122 on part of it. It has the snap ring groove run down int it