Header fitment rant, Doug's

Blu, in my opinion, headers are hard enough to seal without having defects.

There were cuts that are a possible failure point, the flange was not flat and it should be,another failure point.

The studs are coming out, I wouldn't be able to change out the gasket without removing them. Less than 1/4" between passenger side fender wall and header, the drivers side, not a chance.


Since I found the fasteners they sent with them, I'll use them.

Bill. You're absolutely correct, I do the same thing but didn't realize it. Have to take a step back, try to figure out what is going wrong.

I'm not so arrogant that i have to be right, I'd prefer my error is pointed out sooner than later, less painful.