HEI Upgrade but No Spark (kinda)

Looking at my post I realize if I messed up the start/run wiring it might not turn over.
I attached a jumper wire in place of the ballast resistor so it has been deleted.
As to the diagram it's similar to what I did (and its a 4 wire GM HEI module) except I wired in the Magnacor style coil as opposed to the stock coil. Pick up wiring is as pictured and I tested the pickup for ohms and set the gap at .008 and used a new reductor.
I followed Dans upgrade page on Slantsix.org and utilized a relay and followed the wiring on that page. I cant attach it here as I am on my phone enjoying a few PBR and the weather on the deck waiting on the pork! But the thing that gets me is the flash/spark as I release the key to the run position.
Next step is to trace all the wiring from start to finish (ugh!) and go from there.