Holley/Demon Carb stumble

First off thank everyone for the help.

Mattex
Is the "angle channel" #24.... right? If so, they are the same size on both blocks as well as the high or low hole were the IFR is NOT pressed in.
The IFR (pressed in brass insert) in the high/top is .061" esh the lower or bottom (3310) is .054" esh.
Is this right? do they need to be a larger size when there in the top compared to bottom..........or should the size be the same top or bottom.....?
Honestly 12 pages on a carburetor stumble?
At some point you would be thinking in the back of your head that you've given the internet plenty of time to get this sorted out.
I would be strongly thinking about looking for someone in your local area who rebuilds carburetors and having a long discussion with them...