Holley/Demon Carb stumble

Is the "angle channel" #24.... right? If so, they are the same size on both blocks.
upload_2019-8-11_11-51-16.png

and some blocks have a horizontal connection. You can still call it an angle channel. The horizontal channel reduces sloshing and doesn't need a siphon break.
upload_2019-8-11_12-19-17.png

As well as the high or low hole were the IFR is NOT pressed in.
The IFR (pressed in brass insert) in the high/top is .061" esh the lower or bottom (3310) is .054" esh.
Is this right? do they need to be a larger size when there in the top compared to bottom..........or should the size be the same top or bottom.....?
No. too large.