Ebay GT45 + 5.9 Magnum + E85 blow thru
A little update.
Since the motor was out I had a few "might as well" moments. So I decided, might as well strip the engine bay, patch the old header exit holes, patch some other holes in the firewall, clean up some other areas and repaint. I redid my fuel lines, going to move electronics stuff inside the cabin, route front brake lines inside the cabin and away from heat...currently sitting in white epoxy primer.
Might redo the hotside, debating twin Gt35s tucked under the fenders or a single S475.. decisions, decisions.
Rotating assembly is being balanced at the machine shop. Wiseco forged flat tops, Scat forged IBeams, stock cast 5.9 crank. This is the new '94 5.9 I'm building.
A little update.
Since the motor was out I had a few "might as well" moments. So I decided, might as well strip the engine bay, patch the old header exit holes, patch some other holes in the firewall, clean up some other areas and repaint. I redid my fuel lines, going to move electronics stuff inside the cabin, route front brake lines inside the cabin and away from heat...currently sitting in white epoxy primer.
Might redo the hotside, debating twin Gt35s tucked under the fenders or a single S475.. decisions, decisions.
Rotating assembly is being balanced at the machine shop. Wiseco forged flat tops, Scat forged IBeams, stock cast 5.9 crank. This is the new '94 5.9 I'm building.