Tame my 4-speed Stroker....
This "sintered iron disc", I'm probably just going to have to look up on your website and make some kind of decision. I know in my application I need a 10 and a half inch disc with 23 spline. I haven't one problem changing a disc or anything like that. I doubt if I'll invest in anything expensive right away until I at least trash mine...
Sintered iron is just the friction material, it comes in a few different flavors and configurations.
If you have synchros, probably the Ram 900 series disc mentioned earlier would be my choice for iron. It's fairly street friendly with a marcel and damped hub.
A little less street friendly, Ram can make you a "Coyote Special" to suit your input shaft, which has larger iron pucks, no marcel, and a damped hub.
Full face iron is no marcel, no damped hub, and weighs a little over 5lbs with the weight concentrated around the outside. Not synchro friendly.
If yours was the staggered 6 puck I saw earlier in the thread, might not be optimum but will work far better than it did after it's tamed. I actually like the staggered design as it expands the usable wear surface of the flywheel/PP, it also pulls 3 of those pucks closer to the center of rotation which eases the load on the synchros a bit.
EDIT- your tamer went out Friday, should be there tues with mon being a holiday.
Grant