Pieces of steel in cylinder??
Pay attention here folks...
See the hole on the bearing and how small it is compared to the journals dark impression at the oil feed...it is in your interest to make sure this oil hole 5/16 and even slotted. They are not large enough for early blocks main feeds and are offset to boot..so it is more imperative on the early blocks..as said in another thread.
Also pay attention that a certain tech editor disagrees with this... that's some pretty bad judgement from a tech guy wouldn't ya think?
Total curb shitter imo.
Pay attention here folks...
See the hole on the bearing and how small it is compared to the journals dark impression at the oil feed...it is in your interest to make sure this oil hole 5/16 and even slotted. They are not large enough for early blocks main feeds and are offset to boot..so it is more imperative on the early blocks..as said in another thread.
Also pay attention that a certain tech editor disagrees with this... that's some pretty bad judgement from a tech guy wouldn't ya think?
Total curb shitter imo.