My 340 build
So i tried to go further in the build and install the intake and i ran into this problem? Bolt holes wont line up. I did try using the thicker. 065 felpro intake gasket since i had it already but i ordered the .060 felpro gasket(normal one) to see if it will let it go down a bit further. If not i guess shave the intake? My machinist said he doesn't think he took enough off too mess with it but to try the thinner gasket and then go from there. What do u guys think? Its the front left and right that look like they need to vome down a bit? As yoi can see the rear lines up
So i tried to go further in the build and install the intake and i ran into this problem? Bolt holes wont line up. I did try using the thicker. 065 felpro intake gasket since i had it already but i ordered the .060 felpro gasket(normal one) to see if it will let it go down a bit further. If not i guess shave the intake? My machinist said he doesn't think he took enough off too mess with it but to try the thinner gasket and then go from there. What do u guys think? Its the front left and right that look like they need to vome down a bit? As yoi can see the rear lines up