2019 summer race.... Jadaharabi vs 318willrun

318willrun said
well, I can't imagine they cleaned, bored, honed, installed stroker kit all for 100 bucks. I mean, sounds like North of a 1000 for machine work?

Yes it's about 450 for a block prep.. pretty much anywhere.. again what you just don't seem to understand is when I was picking up scrap metal and I would get a load or two after a couple days I would go to the machine shop and drop off $100. And then a week later if I made some more money if I picked up enough for refrigerators washing machines and dryers compressors and old junk I would go to the machine shop and give them another hundred dollars over an entire winter... I was building my dream motor one washing machine and dryer at a time...
what you fully don't understand as I've been enjoying all this horsepower for years on end getting to try it out and all kinds of different ways and situations...
And now it will continue to click out ETS like you have never done before in your own a body... I just keep laughing at the fact that you have no idea what it takes to get your a body to go faster than the 13 second range... again go 11.9 in one of your dusters (and I'm just going to say a naturally-aspirated one more time so you don't get the idea that anybody can toss a nitrous plate on and lose a second or two...) and tell me you didn't spend any money...