What Are You Doing To/With Your Car Today?
Finished cutting out a section of the upper transmission cross member to make some room for the A500. Cut it at the bottom, just inside of the inner tranny crossmember bolt holes. And drilled out 4 spot welds at the top. The flat piece is 1/4" thick by 2-1/2. That's what I'll be welding in, in place of what I removed.
Finished cutting out a section of the upper transmission cross member to make some room for the A500. Cut it at the bottom, just inside of the inner tranny crossmember bolt holes. And drilled out 4 spot welds at the top. The flat piece is 1/4" thick by 2-1/2. That's what I'll be welding in, in place of what I removed.
