dart 67 convertible

Here are some photos of the rocker trim etc.


There should be two on the fender (10 per side assuming the rear most are installed as the OE did it.)

There are screws on the leading and trailing brackets to keep them in and the seals you speak of are a top hat shaped piece of rubber that goes in the hole and on the "fingers" of the bracket. when you spread the fingers they wedge between the rubber and the body. I have a photo of a similar one but cant find it right now.


I did not have enough clips so I spaced them out you can see the hole in the body between the 2 in the photo and in front of the left most one

I can not say if the last 3 are spaced correctly as that quarter was replaced in the 80s. (this photo would show 4 clips but the leading one under the door is not installed)



Passenger side front end

Passenger side rear end

Profile (about 3-4 inches wide)