How to press on right rear axle bearing w Hydraulic press

I pressed on a new bearing this week using a 55 Ton press. I expected the inner race to go further inside the outer rack. When I pulled the axle, the threaded adjuster was screwed in to the point that there was little or no thread showing. It takes almost all of the available threads on the adjuster to push the outer race against the inner race. The photo above shows that I have a couple of threads showing and there’s still about 1/8 inch of play between the inner and outer race. I have just enough thread to close this. I’m guessing that, with 55 Tons of pressure, the inner race must be down against the shoulder in the axle. Does this result look normal?