Red Headed Stepchild-75 Swinger LSX Swap
Picked up my crankshaft from Magnum Machine yesterday after it was finished being balanced.
Then I got my .30 over 6.0 block and 317 heads out today and proceed to strip clean and paint them.
I also cut the coil mounting tabs off a set of extra valve covers, sanded them smooth, sandblasted them, got a 10an fitting welded to one of them for the catch can setup o ceiling the new motor is in, and did a little body work on them to get rid of the factory ls1 dips in the valve covers.
Got everything cleaned up and painted mopar blue(yes its mopar blue not carolina blue like It looks with the flash on).
Will be starting internal assembly this week, as well as doing some hydrodipping on the valve covers and upper intake plenum.
Also got my 350lb springs in the mail from QA1 so I could complete the qa1 coilovers.
Picked up my crankshaft from Magnum Machine yesterday after it was finished being balanced.
Then I got my .30 over 6.0 block and 317 heads out today and proceed to strip clean and paint them.
I also cut the coil mounting tabs off a set of extra valve covers, sanded them smooth, sandblasted them, got a 10an fitting welded to one of them for the catch can setup o ceiling the new motor is in, and did a little body work on them to get rid of the factory ls1 dips in the valve covers.
Got everything cleaned up and painted mopar blue(yes its mopar blue not carolina blue like It looks with the flash on).
Will be starting internal assembly this week, as well as doing some hydrodipping on the valve covers and upper intake plenum.
Also got my 350lb springs in the mail from QA1 so I could complete the qa1 coilovers.