small block 360 cam selection

You may consider something like this.
I have the Lunati 10200701 in my 318, and wouldn't use it again.
There are a few here withe 703. @72bluNblu is running the 10200704.
If I go with a hydraulic flat tappet, I'd go with the 703 listed below.
Voodoo Hydraulic Flat Tappet Cam - Chrysler 273-360 268/276

I am more likely to go with the solid, linked below. I've got 4.10 gears, 2400 stall (I know the TC doesn't match real well, being 100 less than the cam manufacturer recommends but I did talk with them and they said it'd work ok. I want better than ok but it's what I have right now). 308 heads and an RPM Airgap, I'd like to run a 750 AVS2 on this motor, but I have a 650 Holley sitting around, so I may just cheap out and use that instead. Doug's D453 headers. I'll probably just slap in the Unilite dizzy I have sitting on a shelf. I doubt I'll be using the stock bottom end, but I'll stick with the 3.58 stroke. In the next couple of months, the block is going in to the machine shop.
Voodoo Solid Flat Tappet Cam - Chrysler 273-360 264/272