Clutch issue

yellow rose said
If the plate load is LESS than OE you need to REMOVE the over center spring or the clutch will not return to the stop.

If it won't come back and everything else is correct, remove the over center spring.

The previous owner of my E body drilled a small hole in the clutch pedals arm and installed a short spring. The ends were straight to be custom bent.

RAT ROD AL said
It has good bushings all lubed up on installation.

I will check to make sure I have the fork spring on correctly, now if I remove the over center spring and then that doesn't help, I understand that they are a :mad: to put back on if I need to.

There a mutha to remove as well.
I’m staying tuned to this thread. I never had that problem unless it was a diaphragm pressure plate.

4spdragtop said
Correct spring? Is /6 vs sb or bb the same spring?

Now that is something I didn’t think of.