found one problem on the left side///broken power feed pins on the circuit board
used solid copper buzz wire pre tinned everything// used a fiberglass pen to clean everything //soldered everything //checked , bulbs and board for continuity //cut pigtails off of the back,used a dremel tool to sand the backs of the pins flush with the board an a piece of gorilla tape on the back to keep the back from shorting out on the cluster frame.
stronger than factory !!!!!!
View attachment 1715456358
View attachment 1715456359
View attachment 1715456360
View attachment 1715456361
View attachment 1715456362
View attachment 1715456363
View attachment 1715456364
View attachment 1715456365
View attachment 1715456366