Put the decals on with a set of tweezer and then painted the needles with the same orange I painted my Coronet with....
View attachment 1715418149
All done. You can bend the tang at the base of the needle to set how far to the left it goes on the gas and temperature gauges. I set them not to be so far buried....
View attachment 1715418150
The circuits board was really bad. I flattened out the copper foil and then used my SPI Universal Clear and brushed it on to seal and lock in the foil.
View attachment 1715418151
A have no idea where I bought this but it has been in the garage for years. I used it to create a foam seal so the blinker/oil/dash lights don't bleed across in the center of the gauges..
View attachment 1715418152
Not pretty but it will work...
View attachment 1715418153
Here we go all done.
View attachment 1715418154
I installed the clips and nuts to hold the foil down. In a few days I will remove them and polish the foil where we need connections.
View attachment 1715418155
Bead blasted the dash end caps and painted them with OER turquoise plastic paint.
View attachment 1715418156
The top says on by having the "T" rotate in the slot the bottom has a screw..
View attachment 1715418157 View attachment 1715418158