Magnum intake drilling plate project
Okay there's a lot going on in this picture you'll see the brass sleeve on the end of the head that is where I'm drilling out the busted manifold bolt you'll see that the welding clamp is holding the plate in place on the head. The next holder that I have already drilled and tapped it and there's a bolt in it and then the next hole.
I have the tap in it I've already drilled the hole but now I'm getting ready to tap it.
The next hole will get drilled and then tapped. You can see the other two places on the left side of the Jig one of them is the LA manifold bolt hole already drilled and tapped and then the angle Magnum holder on the end of the Jig.
It wound up that each head had a magnum intake manifold bolt snapped off on the End by the water Passage.
Okay there's a lot going on in this picture you'll see the brass sleeve on the end of the head that is where I'm drilling out the busted manifold bolt you'll see that the welding clamp is holding the plate in place on the head. The next holder that I have already drilled and tapped it and there's a bolt in it and then the next hole.
I have the tap in it I've already drilled the hole but now I'm getting ready to tap it.
The next hole will get drilled and then tapped. You can see the other two places on the left side of the Jig one of them is the LA manifold bolt hole already drilled and tapped and then the angle Magnum holder on the end of the Jig.
It wound up that each head had a magnum intake manifold bolt snapped off on the End by the water Passage.